This guide covers the base game on PC version 2.0.77, with normal-quality items and no Space Age or mods. It cross-checks version-pinned developer data and the Factorio Wiki. Fluid-wagon alignment and the 2.1 connection changes are outside this pipe-pump procedure.

Unlocking and connection ports

ItemRequirement or role
Research to unlockFluid handling, which requires Automation 2 and Engine
One pump1 engine unit, 1 steel plate, and 1 pipe
Input and outputTwo ports, at the front and back; the sides do not connect
PowerRequires electricity
FlowOnly in the set direction; it will not pass fluid without power

These are the ingredients for the finished items. Do not confuse an engine unit with an electric engine unit. For two pumps alone, for example, you need 2 engine units, 2 steel plates, and 2 pipes; nearby pipes, tanks, and poles are additional.

Send fluid in one direction: six steps

  1. Choose one fluid. Test with a pipe containing only water, for example. Check the pump's display to confirm that fluid is present on the input side.
  2. Prepare an output. Use a pipe or tank with room that can accept the same fluid. Do not connect it to a different fluid.
  3. Align the front and back. Check the placement arrow so the pump points from input to output. A pipe that appears close to the side is not a connection port.
  4. Connect a power pole. Check the pole's supply area and the power status. Water at the inlet alone will not run a pipe pump.
  5. Check control settings. If circuit conditions or a fluid filter are set, confirm they allow the fluid you want to move. For a first test, start with no conditions.
  6. Watch the output increase. Check the receiving entity's contents. If it fills, provide a consumer or another receiver before continuing.

The order for checking this small setup is an editorial suggestion. Verify one at a time that fluid is available at the input, the connections are correct, power is present, and there is room at the output. Also check for another pipe route that bypasses the pump.

When the fluid will not move

SituationCheck
Input side is emptyIs fluid reaching it from an extraction or production building?
Only the pump does not pass fluidPower, arrow, front and back ports, and pipes
A condition is not metCircuit condition or fluid filter
Output does not increaseFull receiver, different fluid, or connection
Fluid moves by another route even when the pump is stoppedIs there a pipe connection that bypasses the pump?
You cannot draw fluid directly from the shoreWater intake is the role of an offshore pump

For a water source, see Placing an Offshore Pump; for storage, see Storage Tank Ingredients and Connections. Before relying on clearing the destination to make room, check the fluid type and where it is meant to be stored.

Keep 1.1 flow figures and wagon use separate

Use or referenceHow this guide treats it
Moving fluid through a short pipeCheck direction, power, input, and free output capacity
Old pump figure of “12,000/s”Do not reuse it; it changed to 1,200/s in 2.0.7
Long distances or high demandDo not assume one pump is always enough; check actual supply and consumption
Loading or unloading a fluid wagonUse a separate procedure for station stops and wagon connections

The 1,200/s figure is the normal-quality maximum, not a measured rate guaranteed for every pipe layout. Actual transfer varies with upstream and downstream fluid amounts, among other factors. Do not plan by simply adding together the maxima of pumps placed in series.

For train loading and unloading, see Fluid Wagon Connections and Wait Conditions. If a refinery stops because heavy or light oil has nowhere to go, check Oil Cracking and Full Output Checks and inspect each output separately.

Sources and references

Questions and contributions

Share questions, corrections or play reports. Only approved posts for this article and language appear here.

Submit for review

Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.