This guide covers the PC 2.0.77 base game at normal quality on Nauvis, without Space Age or mods. It is checked against developer data and the official wiki. It uses regular Labs; placement and speed measurements have not been tested in-game. It does not cover the 2.1 Lab circuit feature, Bio labs, or maximum-efficiency large builds.

Check which pack types the current research needs

Decide what to send to Labs by checking the packs required by the current technology. A red-only research leaving green packs unused is different from research requiring red and green but stopping because one is missing. First check the started technology and pack types in the research screen.

Multiple Labs work on the same research. They are not machines where each one can select a different technology. If research is complete and you have not started the next one, the Labs will not consume packs either.

One additional Lab costs 10 electronic circuits, 10 iron gears, and 4 transport belts. For a small test, prepare 2 Labs, 1 regular inserter between them, and an electric pole for power. You can hand-feed packs into the first Lab for the test and add automatic supply afterward.

Connect two Labs with an inserter

This is a suggested small test setup. You do not have to replace your entire existing supply line.

  1. Place Labs A and B with a 1-tile gap between the facing sides.
  2. Place a regular inserter in the gap, facing so it takes packs from A and puts them into B.
  3. Put both Labs and the inserter within an electric pole's supply area, then check the power connection from your generators.
  4. Start unfinished research and put every required pack type into A.
  5. Open B and check that packs arrive. Confirm it receives all required types and that research progresses at both A and B.

An inserter can take packs from one Lab and put them into the next. However, this setup does not automatically create enough supply for every Lab you add. If the input packs are limited, both A and B may not run continuously.

Check in order when only the first Lab runs or both stop

StateWhat to checkWhat to try next
Nothing enters BInserter power, direction, and reachable placementTest the A-to-B handoff with one pack type first
B has red packs but no greenResearch requirements and A's inventoryTrace production and input for the missing type
Both have packs but research does not progressCurrent research and powerConfirm research is started and all required types are present
The Labs stop alternatelySupply rate for each typeReplenish the most limited type before adding Labs
Packs are not consumed after research completesSelection of the next researchStart the next technology

To investigate, you can hand-feed a small amount of the required packs into B for comparison. If B runs but the A-to-B handoff does not, that points to the transfer. If hand-feeding does not help, recheck the research, every required type, and power. This is a suggested diagnostic, not a measured throughput result.

Increase supply before adding more Labs

Adding Labs helps when the required packs and power reach them. More surplus red packs will not advance research that lacks the required green packs. Trace each type from the input and check assemblers and transport for Automation science packs and Logistic science pack supply!

If the whole factory stops after adding Labs, return to water, fuel, and poles for steam power and check supply. Research speed and modules can also change demand, so do not treat the 2-Lab setup in this guide as a fixed optimum or promise of research completion time.

If research stops because of technology selection or switching after completion, see Checking the research queue, prerequisites, and saved progress!

Sources and references

Questions and contributions

Share questions, corrections or play reports. Only approved posts for this article and language appear here.

Submit for review

Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.