Scope: PC 2.0.77 base game, normal quality, no mods. The official Wiki sources for the circuit network, red wire, and inserters were checked. Circuit behavior has not been tested in-game. Start by checking the condition with just one chest and one loading inserter.
Separate chest slot limits from a stock-count condition
With a requester chest equipment setup (Japanese article), limit the output chest’s slots to avoid making too much. A circuit reads the count of a specific item in the chest as a signal and uses it to control an inserter.
This example means “load while this chest has fewer than 20 fast inserters.” The value 20 is an editorial example for trying the mechanism, not a calculation of the factory’s total needs. Chest space, power, and materials are also required.
Connect the output chest and loading inserter with red wire
- Identify the loading inserter that moves fast inserters from the assembling machine into the output chest.
- Use Alt+R with the default controls, or select red wire from the shortcut bar.
- Left-click the chest and then the loading inserter to connect them.
- Open the inserter and check its circuit connection and settings.
- Under Enable/disable, set the fast inserter signal, comparison to “less than,” and constant to 20.
- Check its behavior with an empty chest, then inspect the condition after stock increases and after some items are taken out.
In 2.0, red wire is an abstract item selected from the shortcut bar. Do not keep looking for crafting materials based only on instructions for older versions. If you changed a key, use the current binding.
Read the condition at 19, 20, and after taking items out
| Fast inserters in chest | Result of “fast inserters < 20” |
|---|---|
| 0, 10, or 19 | True; loading can occur if other operating conditions are also met |
| 20 or more | False; the loading inserter stops |
| Taken below 20 | True again |
The chest sends its contents to the circuit, and the inserter stops when the condition is false. A signal that is absent from a chest is treated as 0. Select the signal for the finished fast inserters you want to count; do not confuse it with the loading inserter itself.
This does not manufacture exactly 20 items. Items inside the assembler or held by the inserter are not chest stock, and an inserter can move several items at once. A small overshoot alone does not mean the condition failed.
What to check when the count is wrong or nothing moves
| Situation | What to check |
|---|---|
| Chest is below the target but inserter stopped | Less-than versus greater-than direction, signal, constant, power, and source |
| Chest has items but no signal | Is the chest being read the same one that is wired? |
| Signal is larger than expected | Is the same wire color connected to other chests? |
| Value is doubled for one chest | Is the same signal arriving through both red and green wires? |
| Condition is true but inserter does not move | Free space, materials, orientation, and a separate logistic-network condition |
Identical signals on the same network are added together, and the receiving entity adds signals from red and green wires too. Start with one chest and one red-wire network; when expanding, decide which stock locations should be counted.
If you use both a circuit condition and a logistic-network condition, both must be satisfied (AND). If the circuit condition is true but the inserter is stopped, check whether another condition is still enabled. First review inserter direction and belt transport (Japanese article); to switch off power itself, see connecting a power switch!
Sources and references
Questions and contributions
Share questions, corrections or play reports. Only approved posts for this article and language appear here.
Submit for review
Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.