This guide covers PC 1.2 with standard costs and no mods. Wiki text was checked on October 20, 2026; this is not an in-game test. It explains a first ordinary Jump Pad setup, not a specialized long-distance launcher.

Separate unlock costs from the two buildings

Complete Tier 2 “Jump Pads” at the HUB to unlock the Jump Pad and U-Jelly Landing Pad. The milestone costs 50 Rotors, 300 Iron Plates and 150 Cable.

BuildingMaterials for 1Power
Jump Pad2 Rotors, 15 Iron Plates, 10 Cable5 MW while charging
U-Jelly Landing Pad2 Rotors, 20 Cable, 200 Biomass5 MW

Building both costs 4 Rotors, 15 Iron Plates, 30 Cable and 200 Biomass. Count the unlock, poles, wiring and foundations separately. If power is insufficient, start with power failure troubleshooting.

Set the angle and destination using the trajectory preview

  1. Prepare the destination first Wire the U-Jelly Landing Pad and check that its green jelly is visible. Avoid a trajectory that lands outside the pad.
  2. Position the launch pad Select the Jump Pad and place its position with the first click. Watch the trajectory and estimated landing point shown during construction.
  3. Adjust the angle Use the mouse wheel. The range is 0–90 degrees, normally in 5-degree steps. Check for ceilings or walls before confirming construction.
  4. Power it before testing Wire the launch pad too and let it charge. Start with a short route, check that you enter the landing area, and rebuild to adjust if needed.

The displayed trajectory is an estimate. Entering the landing pad’s green jelly prevents fall damage; an unpowered landing pad or bare floor is not equivalent.

Check charging when repeated launches stop

The launch pad stores energy for up to 5 uses. Rapid use can outpace replenishment, so wait until its indicator changes from yellow back to green. Standby draw after charging is 0.1 MW, but allow 5 MW for charging rather than sizing the supply only for standby.

If the launch pad still works during an outage, it may simply have stored energy left. The landing pad also needs power, so a successful launch alone does not verify the safety of a round trip.

If you cannot launch or land safely

SituationWhat to check
Launches stop after repeated useCheck wiring and supply, then wait for the internal charge
You miss the intended destinationRecheck the construction angle, trajectory and obstacles
You take damage on landingCheck landing-pad power and the path into the green jelly

For regular round trips, setting up both ends of a Hypertube is another option. If returning by Jump Pad, prepare and test the return route separately.

Sources and references

Questions and contributions

Share questions, corrections or play reports. Only approved posts for this article and language appear here.

Submit for review

Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.