This covers PC full release 1.2 with standard costs, normal power settings and no mods. The procedure was checked against sources, not tested in game. It covers installing your first generator and connecting it to the factory.
Progress through MAM Caterium research
Research Geothermal Generator in the MAM's Caterium tree. It requires 100 High-Speed Connectors, 1,000 Quickwire and 50 Motors. Completion unlocks generator construction and geyser searches with the Resource Scanner.
Research deliveries and on-site construction materials are separate. The following is for one generator and excludes cable and any intermediate power poles.
| Construction materials for one generator | Quantity |
|---|---|
| Motor | 10 |
| Modular Frame | 25 |
| High-Speed Connector | 25 |
| Copper Sheet | 50 |
| Wire | 250 |
These are regular Modular Frames. Do not confuse them with Heavy Modular Frames, and confirm construction materials remain after researching.
Find a geyser and wire it to the factory
- Complete the MAM research and select geysers on the Resource Scanner.
- Check the geyser and its purity on site, then plan your return route and wiring route to the factory.
- Select Geothermal Generator from the build menu and place it on the geyser.
- Connect it through power poles to the factory grid you want to supply.
- Compare output and consumption on that grid's power graph, checking for shortages when output falls.
For help selecting the scan target, see using the Resource Scanner. This building requires an actual geyser, not an ordinary resource deposit or water surface.
No fuel belt or water pipe is needed. However, power generated on site will not reach the factory without connected wiring. Bring transmission-route materials in addition to those for the generator.
Do not treat average output as a guaranteed minimum
Geyser purity determines the output range, and even the same generator rises and falls over time. A Normal geyser averages 200 MW, but does not constantly produce 200 MW.
| Geyser purity | Output range | Average |
|---|---|---|
| Impure | 50–150 MW | 100 MW |
| Normal | 100–300 MW | 200 MW |
| Pure | 200–600 MW | 400 MW |
For example, if a single Normal generator powers equipment consuming 150 MW, output dropping to 100 MW leaves a 50 MW deficit. This is an illustrative calculation using the table, not a measured in-game result. Before adding equipment based on the 300 MW peak, assess whether low output can support it.
Charging Power Storage and checking reserves can prepare you for temporary shortages. However, simply placing empty storage does not add power. Check whether surplus can charge it and whether reserves keep falling during operation.
Geothermal Generators cannot be overclocked. To raise supply, add other generation or reconsider which consumers run, rather than using shards to upgrade this generator.
Checks when construction fails or power is insufficient
| Symptom | First check | Next action |
|---|---|---|
| Missing from build menu | MAM Geothermal Generator research | Progress through Caterium prerequisites |
| Cannot place on the ground | Are you targeting a geyser? | Scan and place it on the geyser on site |
| Works locally but factory loses power | Does the same grid reach the factory? | Check broken wiring and load |
| Output value fluctuates | Geyser purity and output range | Allow headroom for fluctuations |
| Stored power keeps decreasing | Does generation cover demand over time? | Add generation or reduce consumption |
Fuel-free operation does not guarantee enough factory power. Check the connected grid's graph and stored reserves before deciding whether to add the next facility!
Sources and references
Questions and contributions
Share questions, corrections or play reports. Only approved posts for this article and language appear here.
Submit for review
Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.