Materials for one pair
PC 1.4.5, ordinary worlds without mods; a short route carrying normal water. Make one Inlet Pump and one Outlet Pump. Each needs 10 Iron or Lead Bars and 2 Wire at an Iron or Lead Anvil: 20 bars and 4 crafting Wire per pair, plus separate Wire for the circuit.
Prepare the Mechanic, wrench and lever first. Use one wrench color, Wire, a lever and optionally a cutter. Each pump occupies 2×2 tiles. You do not lay liquid pipes between them.
Six steps to the upper pool
- Separate source and destination. Use a lower source and an enclosed upper basin with floor, sides, safe footing and an exit. Prevent overflow back down or into homes.
- Place the Inlet in the source water. Its tiles must overlap the liquid. Carrying or dropping the item nearby does not install it.
- Place the Outlet in the receiving basin. Leave room for liquid and check the English names so the roles are not reversed.
- Wire all three objects in one color. Connect the lever, Inlet and Outlet through their actual tiles without gaps. The 4 Wire spent crafting is not your circuit supply.
- Right-click the lever to test. With standard PC controls, send one signal at a time. Check that the lower pool loses water and the upper pool gains it. A signal transfers liquid on the pump tiles, not necessarily the entire pond.
- Stop at the needed amount. Repeat while watching levels, inflow and overflow. A lever appearing ON does not continuously send signals.
Check source, outlet and signal
Check water at the Inlet, space at the Outlet and the correct roles first. Then inspect wire color, breaks, object tiles and the lever connection. Wire only running nearby is insufficient.
Expand after one short pair works. See the lamp circuit for basic wiring and The Grand Design for editing. Owning an editing tool does not configure pump roles or triggers.
Transfer is not creation or deletion
Pumps can move liquids including Shimmer, but start with water alone and keep other liquids out of the destination. They can carry lava, yet cannot be placed directly into lava.
Do not rely on old duplication methods. Compare source and destination amounts. For adding water, carrying a small amount or deleting it, use the separate bucket and sponge workflow. Absorbing Shimmer with a sponge deletes it rather than transferring it.
Sources and references
Questions and contributions
Submissions are currently paused. You cannot enter or send a post until reception resumes.