Scope: PC full release 1.2 series, standard settings, no mods. When liquid does not reach a higher location, first check the head-lift limit. Head lift is the height to which liquid can be pushed; it is separate from horizontal pipe distance and supply per minute.
Check head lift and pipe flow separately
Liquid-producing buildings provide 10 m of head lift by default. A Pipeline Pump Mk.1 pushes liquid with 20 m of head lift, and a Mk.2 with 50 m. With a Mk.1, for example, placing multiple pumps at the same height does not add their head lift. If you use another pump on an uphill segment, place it within the head-lift range of the previous pump and confirm liquid reaches it from the supply side.
Head lift is not a measure of how far you can extend a pipe horizontally. Maximum pipe throughput is determined by the pipe tier: Mk.1 carries up to 300 m³/min and Mk.2 up to 600 m³/min. If flow is insufficient, check the liquid producer’s supply, the total demand of consuming buildings, and the pipe tier separately. Adding a pump to a pipeline without a head-lift problem does not change supply or pipe capacity.
Place pumps according to the head-lift indicator
- Connect a pipe from the supply building to the target building and identify where the climb begins.
- Preview a Pipeline Pump and check the displayed head-lift feedback and placement guidance.
- Check whether it is Mk.1 or Mk.2, then add a pump to the uphill segment where head lift is insufficient. Do not stack several pumps at the same height.
- Align the pump arrow with the direction of liquid flow. Pumps do not suck liquid upward, so connect them where liquid can reach from the supply side.
- Connect power to the pump and fill the pipeline with liquid before running the consuming building.
The placement preview’s head-lift feedback shows an indication of the upper limit. If the limit at the proposed location does not reach the target height, check by placing another pump partway up the climb. Some placements may not display an indicator, so do not assume a fixed “every 20 m” spacing; use the pump tier and on-screen feedback.
If liquid does not arrive or flow is insufficient
| Symptom | What to check |
|---|---|
| Liquid does not reach a higher building | Producer’s 10 m head lift, Mk.1/Mk.2 limits, and preview head-lift indicator |
| It still will not rise after adding a pump | Pumps are not stacked at the same height; check direction, power, and liquid on the supply side |
| Height is sufficient but supply cannot keep up | Supply and demand, plus the 300 m³/min Mk.1 and 600 m³/min Mk.2 pipe limits |
| Flow is unstable | Whether the long pipeline is full, and changes from splits, merges, or consumption |
An empty long pipeline takes time to fill. Check the liquid in the pipes and the supply rate before adding pumps. A setup where liquid production barely matches total consumption may leave the far end short when flow fluctuates.
This guide is based on cross-checking the text of the Satisfactory Japanese Wiki articles “Automation/Liquid Transport” and “Buildings/Logistics.” No pipeline tests were performed in-game. Large split-and-merge networks with elevation changes, Nitrogen Gas, and mods are outside scope.
Sources and references
Questions and contributions
Share questions, corrections or play reports. Only approved posts for this article and language appear here.
Submit for review
Do not include personal details, passwords or private information about others. Text only. Publication and replies are not guaranteed.