Craft one sensor
At a crafting table, place one ordinary sculk sensor in the centre, with an amethyst shard above it and one on each side. This makes one calibrated sensor. Use three shards, not amethyst blocks; calibrated sensors do not generate naturally.
Bring Silk Touch to collect the ordinary sensor, and use it again when moving the calibrated block. Do not break the equipment first and only then check the tool. See collecting amethyst for the shard supply.
Start with an input of 1
The amethyst-marked face accepts the filtering input. A stronger input selects a different category; it does not simply improve detection.
- Place the sensor on a safe floor away from an ancient city.
- Point a comparator's output directly into the input face.
- Put a chest behind the comparator, empty it, then add one cobblestone. Use comparison mode without side inputs to obtain strength 1.
- Add a short output wire on another side of the sensor, separate from the input wire.
- Walk normally nearby and observe the sensor and output. Pause between attempts.
This is a diagnostic layout proposal, not a claimed in-game test. Check comparator orientation and modes if needed.
Filtering input is not output strength
| Input | Example category |
|---|---|
| 1 | Movement |
| 9 | Block deactivation, such as closing a door |
| 10 | Block activation, such as opening a door |
Opening and closing the same door are different events. Selecting 10 does not mean the sensor always outputs strength 10. Check the output wiring separately. A repeater placed in the input path will not preserve the original strength, so begin with direct, short wiring.
The official Java and Bedrock 1.20 release notes specify detection up to 16 blocks, a combined active/cooldown cycle of 20 game ticks and output during the first 10. Test one nearby action at a time rather than overlapping actions during this cycle.
Diagnose a missing or wrong response
- Responds to everything: check that the block is calibrated and that the intended strength reaches its input face.
- Ignores walking: return to input 1, walk normally nearby, and rule out sneaking or wool blocking the vibration.
- Works only once: leave a pause and separate input and output wires.
- Ignores a closing door: check category 9 rather than opening category 10.
For converting mob experience into terrain, use the sculk catalyst guide. Filtering is not protection against nearby shriekers or wardens.
Versions
Scope: normal survival in Java 26.3 and Bedrock 26.50, checked against official releases, recipe and names. Snapshot, Preview and modded circuits are excluded. Controls and circuit details are not assumed identical on every device; begin with the small layout.
Sources and references
Questions and contributions
Submissions are currently paused. You cannot enter or send a post until reception resumes.